Bo Mạch Chủ 2 Chiều Bằng Nhôm Cho Máy In 3d

Giới thiệu Bo Mạch Chủ 2 Chiều Bằng Nhôm Cho Máy In 3d

Completely soe the problem of hot bed power and load current being too large; General add-on heated bed power expansion ule.
With this add-on ule to your 3D printer motherboard you can lead the maximum current up to 25A; Under normal cooling, it will work stable under I( Max)=25A, and the current must not exceed 25A while working.
ule board dimension: 60*50mm; Mounting holes diameter: 3.2mm, for M3 screws.
According to the thermal power of the bed, please choose the appropriate power supply, with sufficient margin. If it is large power heated, we suggest 24V power supply, under the same power requirements, current is less than 12V.
This ule is also recommended if you intended to use a heated bed with your 3D printer that uses 12V power supply, else it may cause excessive current during times which may burn the connectors on the controller board.

Type: MOS tube
colour: black
Material: ABS

Package Contents:
2 x accessory heating platesOnly the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Giá SEBA