Bo mạch chủ Ramps 1.5 kèm cảm biến cảm ứng 3D tự động dành cho máy in 3D

Giới thiệu Bo mạch chủ Ramps 1.5 kèm cảm biến cảm ứng 3D tự động dành cho máy in 3D

Ramps 1.5 Motherboard with 3D Induction Sensor Automatic Leveling Sensor for 3D Printer
Features:
It can be connected to LCD and other parts, There are heater and fan MOSFET outputs and 3 thermistor interfaces.
5A additional security and component protection fusion, Heated bed controls additional 11A fuses.
Applied to 5 Pololu stepper drive board, Design of Pololu plate pin socket can be easily replaced or removed for future design.
I2C and SPI pins are available for future expansion.
Servo connectors are used for connecting limit stops, motors and light-emitting diodes. These connectors are gold-plated and have a rated current of 3A, which is very compact.
3D Induction Characteristics:
1. 3D Induction can be easily applied because of its small size and simple structure. Gathering information and firmware settings will be an easy task, because the 3d Induction works as usual, the automatic bed leveling sensor.
2. Intelligence: self test: push the nail operation two times when the power is on.
3. High precision: the standard deviation of repeatability 3d Induction is about 0.005mm, and the accuracy is high.
4. The stationary state, while the pin pulled out or retracted, no current flow solenoid valve, the standby current of the equipment is lower than the average current of 15mA, and in the work state, pin suddenly moves about 100ms the equipment back in less than 300mA. Low power consumption even further reduces Joule heating to prevent heat problems.
5. Bed width selection:
3d Induction does not use any light, do not close (the inductance / capacitance sensor).  3d Induction control through the Holzer effect, providing high accuracy. So the bed material is free to choose.
6. 3D Induction is an auto leveling sensor for 3D Printers that can precisely measure the tilt of your print surface.

Specifications:
Set: Ramps1.5 + 3D Induction Sensor
3D-Induction: Automatic Leveling Probe
3D-Induction Edges: Simple, Compact, High Precision, Good Compatibility
Motherboard Size: 10.2 * 6 * 1.5cm / 4.0 * 2.4 * 0.6in
Motherboard Weight: 56g / 2.0oz
Package Size: 22 * 13 * 3cm / 8.7 * 5.1 * 1.2in
Package Weight: 150g / 5.3oz
Packing list:
1 * Ramps1.5
1 * Induction probe
2 * M2.5 Screw
2 * M2.5 Nut
1 * 1m DuPont Line 2pin Female to Mother
1 * Several Jumper Caps
Giá GCAKE